![]() ![]() That normally means it aint plugged into your computer. In addition I've tried to change USB-Port several times, but still nothin' :\Īnd also this has started happening recently, so it has worked fine earlier.Īnd last, please excuse my bad english ^^ Restarting TPS2 normally solves it but can be annoying.Īs I mentioned, I CAN find the controller in the Device Manager, so I doubt it's faulty connected. Have you tried a different cable? Is it plugged into your computer or a hub? Have you tried a different port on your computer? Does the computer have some type of power save feature on the USB's? As I mentioned in the first post I can find the controller in Device Manager, with no problems detected (It has happened a few times earlier, but then I just re-plugged/restarted the controller, and everything was fine.)ĮDIT: And yeah, I doubt it's the cable. I'm 90% sure that it's not my cable and not my USB-ports.Īs I mentioned, this started yesterday for real. Yes, I've tried switching cable two times. No hub, I've tried switching USB-ports like 20 times. Other than that, im stumped to what your issue may be I know sometimes USBs can tend to loosen up after a whileĪlso, as i said earlier, make sure your cable is pushed in fully into your S4, it is quite a tight fit. This HAS happened a couple of times earlier, but a restart of either Traktor or the controller fixed that. IF the cable was the problem, it would show an error in Device Manager, or not be connected at all. just make sure you backup your traktor files. Happen to me once and all i did was a reinstall. Im believeing if you should reinstall the whole thing, culd be a driver error. I believe reinstalling may be the answer, or maybe updating the driver. While it may not be the cable that light flashes fro a specific reason so there's something along those lines that causes the problem. When I say that the master-LED flashes, I mean that it stays lit. Really confused as I've been traveling for a bit and came back to my S4 like this after driver and software updates.ĭammit. My USB and Power Cable are fine, I mean I'm getting sound from the TT out to the speakers. For some reason I can run my TTs through Live Input on Phono and get Master Volume Control and Meters to work, but nothing else. Turntables work and both sides not just deck D? have you tried reverting back to the older drivers? I'll try and reset everything tomorrow and hopefully something works! I had it set to old drivers before I updated. Flashing probably indicates a connectivity problem with your USB connection. So does anybody have an Idea what this could be?The normal behavir when the S4 is connected (USB) and Tracktor isn't running is for the USB light to stay lit (not flashing). S with this problem, but all in all, no solutions. I've seen a couple of threads on different community I've also checked device manager and I CAN see the controller in the USB-hub section. I've restarted the controller, Traktor 2 and my computer. When I plug my controller, all the lights blinks one time, like it does on every start-up of the controller.īut when that's done, the only thing flashing is the Master(USB?)-LED. I've been experiencing a problem lately with my Traktor Kontrol S4. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |